Register    |    Sign In   |   
electronic MUSICIAN

Sabor! Recording Latin Percussion Harrison AR

For the general take of the band, I place the band in a semi-circle and set a couple of mics in an ORTF (Office de Radiodiffusion Télévision Française, named after the developers of this technique) arrangement in the center so the distance to the mics is distributed equally.

Guitar Smiths Inc.
(870) 741-4002
112 E. Stephenson Stret
Harrison, AR
 
Golden Pawn Shop
(870) 741-6204
815 Highway 62 65 N
Harrison, AR
 
Guitarsmiths
(870) 741-4002
112 E Stephenson Ave
Harrison, AR
 
Ronnies Steel Gtr
(501) 623-4603
625 Albert Pike Rd
Hot Springs, AR
 
All Star Music
(870) 931-5600
3707a E Highland Dr
Jonesboro, AR
 
Capital Pawn
(870) 741-4782
1404 Highway 62 65 N
Harrison, AR
 
Ashley Music Store
(870) 741-8315
1510 N Main St
Harrison, AR
 
Little Rock Frets
(501) 681-5712
10301 N Rodney Parham Rd Ste5 Bldg E
Little Rock, AR
 
Bensberg Music Store
(870) 862-6844
727 North West Ave
El Dorado, AR
 
Sigler Music
(479) 751-5961
4401 S Thompson
Springdale, AR
 

Sabor! Recording Latin Percussion

THE MAIN PERSPECTIVE

Recording Latin percussion is somewhat tricky; even though the number one audio rule is “there are no rules,” recording and mixing good Latin ensembles requires some knowledge about the overall sound and a general perception about how to mix them stylistically. It’s even more demanding when you can’t be at your comfortable multi-channel studio, with a big live room that has space and mics for the whole band. You’ll still need at least one general take of the band — or the percussion section with the bass — so the rest of the band can play over it to get their own tracks recorded individually; you’ll also need a good set of mics, like a couple of ribbons, a couple of SM57s, and some condenser cardioids.

For the general take of the band, I place the band in a semi-circle and set a couple of mics in an ORTF (Office de Radiodiffusion Télévision Française, named after the developers of this technique) arrangement in the center so the distance to the mics is distributed equally. As this technique uses cardioids, try some M930s (Figure 1). The mics can sit further back from the source without capturing too much of the reverberation compared to other techniques, enabling you to use this in over-reverberant spaces where other techniques would capture too much of the acoustics.

LAS CONGAS

To get the most natural vibe, don’t pan congas all the way to opposite sides. Actually, recording good congas — or bongos, timbales, zurdos, djembes, or any other good set of percussion — does not need to be done in full stereo, given they will sit better when they’re together at the same side of the stereo field. Place a condenser-cardioid mic in the center of the two congas, at a 45° angle, one foot away of the set, and you are done (if desired, you could record them with separate mics to have extra control on individual channels for EQ). Replacing the 414s with SM57s is common, but that depends on the song’s dynamics.

Record every set of percussions individually, then recreate that in your mix. Pan the congas slightly to one side, the smaller percussion in the center, and timbales to the other side. The “more cowbell” rule also applies; you can sit the set of cowbells to the same side as the timbales, as that’s their natural position.

LOS METALES

You’ll find too that the brasses are all at the same side of the stage, so panning the trumpet to the center, the sax to the right and the trombone to the left is highly unrealistic.

Recording the brass with a dynamic microphone could suck some life out of the performance, but combining it with a ribbon microphone can help to capture most natural brass tones. Don’t close-mic the instrument; the mic needs to get some of the room sound. When recording trumpets alone, place the mic below the bell’s line-of-sight, rotated at about 40° to avoid higher SPL levels and tilted upward, about 4–6 feet from the trumpet’s bell.

To record a three-to-five piece brass section, I like using the ORTF technique...

Click here to read the rest of the article from EQ Magazine

Discover Emusician