Register    |    Sign In   |   
electronic MUSICIAN

Sabor! Recording Latin Percussion Glendale AZ

For the general take of the band, I place the band in a semi-circle and set a couple of mics in an ORTF (Office de Radiodiffusion Télévision Française, named after the developers of this technique) arrangement in the center so the distance to the mics is distributed equally.

Sam Ash Music
(602) 863-7746
4402 West Cactus Road
Glendale, AZ
 
Sam Ash #61
(516) 932-6400
4402 W Cactus Rd
Glendale, AZ
 
Atomic Guitar Works
(623) 878-4127
8550 N 91st Ave Ste 52
Peoria, AZ
 
Music & Arts Center #4301
(602) 504-0206
5350 W Bell Rd Ste 132
Glendale, AZ
 
Music & Arts
(602) 504-0206
Desert Glen Shopping Center, 5350 West Bell Road Suite 132
Glendale, AZ
 
Sam Ash Music # 61
4402 W Cactus Rd
Glendale, AZ
 
Bass Place, The
(623) 583-2911
9880 W. Peoria Ave
Peoria, AZ
 
The Bass Place
(480) 423-1161
5420 W Camelback Rd Ste 4
Glendale, AZ
 
Guitar Center #152
(602) 375-3800
2750 W Peoria Ave
Phoenix, AZ
 
Guitar Center Phoenix
(602) 375-3800
2750 West Peoria St.
Phoenix, AZ
Store Information
Mon-Thur: 11-9
Fri: 10-9
Sat: 10-8
Sun: 11-6

Sabor! Recording Latin Percussion

THE MAIN PERSPECTIVE

Recording Latin percussion is somewhat tricky; even though the number one audio rule is “there are no rules,” recording and mixing good Latin ensembles requires some knowledge about the overall sound and a general perception about how to mix them stylistically. It’s even more demanding when you can’t be at your comfortable multi-channel studio, with a big live room that has space and mics for the whole band. You’ll still need at least one general take of the band — or the percussion section with the bass — so the rest of the band can play over it to get their own tracks recorded individually; you’ll also need a good set of mics, like a couple of ribbons, a couple of SM57s, and some condenser cardioids.

For the general take of the band, I place the band in a semi-circle and set a couple of mics in an ORTF (Office de Radiodiffusion Télévision Française, named after the developers of this technique) arrangement in the center so the distance to the mics is distributed equally. As this technique uses cardioids, try some M930s (Figure 1). The mics can sit further back from the source without capturing too much of the reverberation compared to other techniques, enabling you to use this in over-reverberant spaces where other techniques would capture too much of the acoustics.

LAS CONGAS

To get the most natural vibe, don’t pan congas all the way to opposite sides. Actually, recording good congas — or bongos, timbales, zurdos, djembes, or any other good set of percussion — does not need to be done in full stereo, given they will sit better when they’re together at the same side of the stereo field. Place a condenser-cardioid mic in the center of the two congas, at a 45° angle, one foot away of the set, and you are done (if desired, you could record them with separate mics to have extra control on individual channels for EQ). Replacing the 414s with SM57s is common, but that depends on the song’s dynamics.

Record every set of percussions individually, then recreate that in your mix. Pan the congas slightly to one side, the smaller percussion in the center, and timbales to the other side. The “more cowbell” rule also applies; you can sit the set of cowbells to the same side as the timbales, as that’s their natural position.

LOS METALES

You’ll find too that the brasses are all at the same side of the stage, so panning the trumpet to the center, the sax to the right and the trombone to the left is highly unrealistic.

Recording the brass with a dynamic microphone could suck some life out of the performance, but combining it with a ribbon microphone can help to capture most natural brass tones. Don’t close-mic the instrument; the mic needs to get some of the room sound. When recording trumpets alone, place the mic below the bell’s line-of-sight, rotated at about 40° to avoid higher SPL levels and tilted upward, about 4–6 feet from the trumpet’s bell.

To record a three-to-five piece brass section, I like using the ORTF technique...

Click here to read the rest of the article from EQ Magazine

Discover Emusician