Register    |    Sign In   |   
electronic MUSICIAN

Planning Your Resources Tuscaloosa AL

It's kind of ironic that sometimes, using good gear at 24 bits will actually sound "cheaper," as your recordings will reproduce unwanted noise and crud from the environment far more faithfully. So be it. Just don’t take your best mics to all of your gigs; if there are noisy environments, leave the U-47s at home.

Tuscaloosa Music
(205) 752-7524
1408 2nd Ave.
Tuscaloosa, AL
 
Guitar Gallery Inc Tuscal
(205) 758-2202
309 Hargrove Rd. East
Tuscaloosa, AL
 
Guitar Gallery Inc
(205) 758-2220
2300 Mcfarland Blvd E
Tuscaloosa, AL
 
Eat My Beats
(205) 344-9118
1020 15th St
Tuscaloosa, AL
 
Southeastern Music Gallery
(205) 345-1414
5500 Old Montgomery Hwy
Tuscaloosa, AL
 
Tuscaloosa Music Service Inc
(205) 752-7524
1408 2Nd Ave
Tuscaloosa, AL
 
Stringed Instr. Repair
(205) 758-3838
2300 Mcfarland Blvd. #7
Tuscaloosa, AL
 
Tuscaloosa Music Service Inc
(205) 752-7524
1408 2nd Av
Tuscaloosa, AL
 
Decade Music Exchange
(205) 750-0095
620 14th St Ste F
Tuscaloosa, AL

Data Provided by:
Barnes & Noble Booksellers
(205) 349-6366
1800 Mcfarland Blvd E,Ste 200
Tuscaloosa, AL
 
Data Provided by:

Planning Your Resources

JUSTIFY MY BITS

As analog circuitry is the weakest link in the recording chain, without good equipment such as quality preamps, mics, and even clean sources of power, the benefits of a 24-bit recording will be compromised. Unbalanced analog connections are susceptible to inducing noise from the environment, and can also promote the creation of ground loops. Also, running a signal with an unbalanced stage in it will likely negate the benefits of 24-bit recording by lowering the signal-to-noise ratio of the total analog stage; devices with unbalanced outputs, that can’t provide levels above +12dBu, typically do not offer great enough dynamic range to justify 24-bit A/D conversion. 

It’s kind of ironic that sometimes, using good gear at 24 bits will actually sound “cheaper,” as your recordings will reproduce unwanted noise and crud from the environment far more faithfully. So be it. Just don’t take your best mics to all of your gigs; if there are noisy environments, leave the U-47s at home.

Of all the reasons we may have to record at 24 bits, headroom is one of the greatest justifications. As every bit offers approximately 6dB of dynamic range, with 16 bits we achieve 96dB and with 24 bits, we go all the way up to 144dB. A recording with peaks hitting –12dB maximum will still take advantage of a theoretical 22 bits’ worth of dynamic range and resolution. The result: greater quality for lower level signals, without any clipping.

Once you realize that there are some technical considerations involved in taking full advantage of those extra 8 bits, and that a 24-bit recording takes more space on your hard disk (see Figure 1), I still believe it’s well worth recording with 24-bit resolution. You can record at lower levels, quiet passages won’t be struggling to stay above your system’s noise floor, and you’ll give your converters some breathing room. Not a bad deal . . . now let’s move on to selecting a sample rate.

WHAT ABOUT SAMPLING RATES?

It makes no sense to record a politician’s three-hour speech, or an interview with a wasted rock star for the local newspaper, at 24/96 just to transcribe it to print later on. Built-in microphones on your portable solid-state recorder will do the trick, and recording at 128mbps MP3 will save tons of space on your memory card.

Some instruments with delicate high frequency content may benefit from being recorded at 88.2 or 96kHz instead of 48kHz, but the differences will be subtle. It’s often better to use a higher-quality mic/preamp combination and record at 44.1 or 48kHz than record at 96kHz with your interface’s onboard preamps.

Without getting sucked in to those endless discussions about whether an average human can really hear — or even care about — the difference between a 44.1 or 96kHz sampling rate, we can probably all agree that our choice of sampling rate will depend on the delivery media of our recorded material. If it is audio for commercial CDs or data-compressed formats (e.g., MP3, WMA, AAC, A...

Click here to read the rest of the article from EQ Magazine

Discover Emusician